Switch to full style
The new home for CubFest and Tractor show Announcements & Discussions.

Forum rules

ALL CubFest discussion posted in other forums will be moved to this forum without advance notice.

IMPORTANT NOTE: CubFest organizers -- Notify a TeamCub member or the ADMIN (Dennis) to "Sticky" your event announcement in this forum.
Post a reply

Re: Cubfest Northeast Projects

Fri Sep 21, 2012 9:08 pm

I would love to see if I can get my hydraulics working. Went through the pump several times and know that is not the issue. The TC just had the strainer replaced and looked really clean inside...not sure what is up with. And have some brakes to reline so will PM Bob to inquire about that.
.
Was bringing local cranberries up for Rudi, Pris and anyone else who might want a small sack of them from a friend's cranberry bog. :D

Re: Cubfest Northeast Projects

Tue Sep 25, 2012 3:37 pm

I've got four Woods 59 spindles that need to be rebuilt. I'm willing to do one, at least, to show folks how I do it.

Bill

Re: Cubfest Northeast Projects

Wed Sep 26, 2012 8:20 am

Would anyone be interested in mowing a hayfield east of Cecil's?? If you have a Cub with a mower (and a trailer) it may be a nice Friday project, takes most of the day with a C-2 (42") but if we had a couple of Cubs it would be a great side project. I will check to see if any plowing etc is needed. Farm is owned by a good friend's daughter and son-in-law and they don't have a tractor (but do have a Gravely L).

I will probably drag along the right angle pulley off my Mott (bad front seal) and another one. Working on the parts list now.

Bill, I will surely watch your demo!

Re: Cubfest Northeast Projects

Wed Sep 26, 2012 11:45 am

Larry, do they want it cut to be baled or just mowed?

Re: Cubfest Northeast Projects

Wed Sep 26, 2012 6:43 pm

Just cut.... don't know if we cut it if someone would bale it later?? Essentially they have had a guy with one of those green tractors rotary mow it for the last few years.

Re: Cubfest Northeast Projects

Mon Oct 08, 2012 3:41 pm

Bill Hudson wrote:I've got four Woods 59 spindles that need to be rebuilt. I'm willing to do one, at least, to show folks how I do it.

Bill


Folks,

I will not be doing the spindle rebuild. Too much going on and I failed to order parts. I'm sorry.

Bill

Re: Cubfest Northeast Projects

Tue Oct 09, 2012 3:02 pm

I am going to bring the 1963 F cub that I bought in NH this past summer. I have a short some where, the battery goes dead if you leave the cables on. I had the genorator rebuilt.
Also the TC is leaking and I am going to replace some gaskets and see if that fixes the problem.

Re: Cubfest Northeast Projects

Tue Oct 09, 2012 4:41 pm

You might have a bad voltage regulator.

Re: Cubfest Northeast Projects

Tue Oct 09, 2012 5:46 pm

Turns out the farm could use mowing AND plowing..... Thinking it would be best either Friday or Sunday. It's about 20 minutes away.

I may replace the bushing in the fast hitch C-2 mower spindle pulley. All depends on if it shows up in time.

Re: Cubfest Northeast Projects

Tue Oct 09, 2012 6:12 pm

Larry:

Buzzard Wing wrote:I may replace the bushing in the fast hitch C-2 mower spindle pulley. All depends on if it shows up in time.


I would want in on that one -- interesting project.
Post a reply