Mid TN Cubfest projects
Posted: Wed Aug 15, 2012 8:50 am
1. Josh Blair's electrical wiring and ignition switch
2. Lloyd's tune up, clean and adjust carb, valve lash, generator (non-runner)
3. 184 rear main seal, clutch, carb ..........
4. flush inside of rusty tank
5. replace pto on Jan's cub, hyd pump seal, install deluxe seat and bent shifter
6. I have a new barn find(non runner), a '48 that I have not touched. I thought it would be a good one to demonstrate the proccess of evaluating and testing a new cub from rolling it off the trailer, to starting and using it.
7. tune up Larry's cub (has a miss) also loosen governor/throttle rockshaft (stuck)
I am sure there are more projects out there. If you have one to bring, lets get it on the list.
ANY OF MY PROJECTS WILL COME AFTER THE OTHERS
Currently there are 4 cubs in the front yard, and more on the way
2. Lloyd's tune up, clean and adjust carb, valve lash, generator (non-runner)
3. 184 rear main seal, clutch, carb ..........
4. flush inside of rusty tank
5. replace pto on Jan's cub, hyd pump seal, install deluxe seat and bent shifter
6. I have a new barn find(non runner), a '48 that I have not touched. I thought it would be a good one to demonstrate the proccess of evaluating and testing a new cub from rolling it off the trailer, to starting and using it.
7. tune up Larry's cub (has a miss) also loosen governor/throttle rockshaft (stuck)
I am sure there are more projects out there. If you have one to bring, lets get it on the list.
ANY OF MY PROJECTS WILL COME AFTER THE OTHERS
Currently there are 4 cubs in the front yard, and more on the way