Page 1 of 1
Needle valves and seats to the Bash
Posted: Tue May 22, 2012 6:44 pm
by Bob McCarty
I was measuring some old ones this afternoon. To my surprise, I found three different ID's on the seats, and two OD's on the needles. Enough difference that they are not interchangeable. If you have some old ones and are attending the Bash, please bring them so I can measure them. It may not clarify anything, but I've been in a state of confusion most of my life anyway.
Bob
Re: Needle valves and seats to the Bash
Posted: Tue May 22, 2012 6:50 pm
by Barnyard
Bob McCarty wrote:but I've been in a state of confusion most of my life anyway.
Bob
So that's why I am still finding things you hid at the bash last year!
Re: Needle valves and seats to the Bash
Posted: Tue May 22, 2012 7:20 pm
by Boss Hog
I will try to round up some
Re: Needle valves and seats to the Bash
Posted: Tue May 22, 2012 8:04 pm
by Mr E
Barnyard wrote:Bob McCarty wrote:but I've been in a state of confusion most of my life anyway.
Bob
So that's why I am still finding things you hid at the bash last year!
All of us that have hosted a Fest have a special appreciation for this statement.
Re: Needle valves and seats to the Bash
Posted: Wed May 23, 2012 6:11 am
by sdurnal
Bob, I have a new one from a TSC kit that has a viton tip, if it will do you any good. (After reading the comments about them, I re-used the old one) Can't explain why I kept it.. Just did..
Regards,
Re: Needle valves and seats to the Bash
Posted: Wed May 23, 2012 8:38 am
by Denny Clayton
sdurnal wrote:Bob, I have a new one from a TSC kit that has a viton tip, if it will do you any good. (After reading the comments about them, I re-used the old one) Can't explain why I kept it.. Just did..
Regards,
In case you needed it later..............if you can find it.
Re: Needle valves and seats to the Bash
Posted: Wed May 23, 2012 10:17 am
by sdurnal
Me thinks you speak from experience, Denny! hehe cya soon..