Gib keys

Anything that might not belong on the other message boards!

Moderator: Team Cub

Forum rules
1. Keep it clean.
2. Keep the discussion civil.
3. Name calling is not allowed.

Politics and religion are two topics that tend to degenerate into a violation of one of the three simple rules above.

The mods and the site admin reserve the right to "lock" or "delete" any discussion that in our opinion, is "heading in the wrong direction."

MOST of all, be respectful of your fellow Cubber's opinions. Don't expect to change someones belief system from a simple forum on the internet.

Re: Gib keys

Postby sdurnal » Fri Sep 28, 2012 1:20 pm

Well, I didn't intend this post to get out of hand, only wanted to offer my services if so desired at a Cubfest. Really too involved for me to try to explain here. Sometimes it is necessary to use a big sledge and pipe to break them loose, Al, driving the hub away from the taper. (In addition to the key extractors in my attachment, following.) These are not as simple as appears, they are a compound taper, which holds them into the slot between the head of the key and the hub. I've actually seen these made in our factory, next to the combine assembly line. They used to be hardened by hand, but now is automated, as is the cutting and plating process.
The curved one removes the keys from an inset (dished) hub. Yes, there are some instances where it has been necessary to drill out the key, but if "fitted" correctly and not distorted by a BFH, they normally come out. Then again, I've not had to remove any that are more than 60 years old, either.
We sell around 200 extractors a year thru our dealer network, and are used on balers, forage harvesters, and combines. (yes, built in 2012)
I did not intend this as a sales pitch either, so take it as it is..
I hope this helps in some small way. (that was my only intention) Regards, Stan
Attachments
~keypullers.jpg
User avatar
sdurnal
501 Club
501 Club
 
Posts: 745
Joined: Thu May 06, 2010 1:36 pm
Location: IN, Columbus
Zip Code: 47201
Tractors Owned: 105 & 127 cadet (sacrificed for a 4wd project)

680 Cadet
1964 LoBoy FH
L-54A Blade
Pennington 3 spindle deck
LF-194 plow
Circle of Safety Award
Circle of Safety: Y

Previous

Return to Off Topic

Who is online

Users browsing this forum: No registered users and 1 guest