Page 1 of 1
parts required fo fix hyd pump?
Posted: Sun Apr 06, 2014 8:29 am
by 64/67lo-boy
I was wondering what parts are needed for fixing the seals on the hydrolic pump. Leaks in to crankcase. Can this be fixed with O rings and gasket material or do i need to purchase a kit?
Like to have materials on hand for Va CubFest.
Re: parts required fo fix hyd pump?
Posted: Sun Apr 06, 2014 8:37 am
by tst
the pump could have a oring or a seal on the shaft, if it needs a seal you will need a kit, you can check but I do not think they sell the seal separate, the oring type can be had
Tim
Re: parts required fo fix hyd pump?
Posted: Sun Apr 06, 2014 8:59 am
by Boss Hog
O ring, I should have one, can pick one up at work if I dont
Re: parts required fo fix hyd pump?
Posted: Sun Apr 06, 2014 3:13 pm
by Don McCombs
The shaft seal (o-ring) is 1/2 X 11/16 X 3/32 #112.
Be sure to get one made of Buna-N to resist hydraulic oil.
Re: parts required fo fix hyd pump?
Posted: Sun Apr 06, 2014 5:09 pm
by Bob McCarty
You may want to have gaskets for both ends in case one gets torn or needs replaced. TM is an easy place to get them from. The gasket material they are made of is a lot stiffer (maybe because of the pressure involved) than the gasket material normally used. I've never looked for it myself.
Bob