might have a leaky oil pump

Fri Mar 07, 2014 7:17 pm

Checked the oil in the crank case and it was higher than the mark. was going to change the fluids but thought it would be better just to top them off and drain some out of the crank case. Run it and check to see if any levels change. No drips around tractor so everything seams pretty tight. The tractor is a 154 built towards the end of 1974. Not sure what pump it is. Can I put a new seal on the shaft or do I have to rebuild it with a kit?
IMGP1189.jpg
You do not have the required permissions to view the files attached to this post.

Re: might have a leaky oil pump

Fri Mar 07, 2014 7:20 pm

you can put an O ring on it