Page 1 of 1
crankshaft pulley puller for 154/184/185?
Posted: Mon Mar 03, 2014 9:18 pm
by RustyKnuckles
What do people use to pull the large-diameter pulley found on these tractors? The fixtures people make up for Cubs are of course too small.
Re: crankshaft pulley puller for 154/184/185?
Posted: Mon Mar 03, 2014 9:27 pm
by RaymondDurban
Remove the bolt and washer from the end of the crankshaft and it'll pull right off. I've removed a couple, no tools required.
Re: crankshaft pulley puller for 154/184/185?
Posted: Tue Mar 04, 2014 12:57 am
by RustyKnuckles
You mean, this pulley is not an interference fit, as it is with the Cubs?
Re: crankshaft pulley puller for 154/184/185?
Posted: Tue Mar 04, 2014 9:32 am
by gitractorman
No, there's a key in it, so like Raymond said, just pull the bolt and the pulley will come of pretty easy. I've had to replace a few of those keys.
Re: crankshaft pulley puller for 154/184/185?
Posted: Tue Mar 04, 2014 12:14 pm
by Andrew Z
I two / three jaw puller can be used if its stuck on there. However they are not like the early cubs at all in the degree of difficulty to remove.
Andrew
Re: crankshaft pulley puller for 154/184/185?
Posted: Wed Mar 05, 2014 8:46 am
by outdoors4evr
When you pull it off, inspect the key and the pulley hub area for wear. 1/2 my key was worn off.