Page 1 of 1

working on a lo boy soon

Posted: Wed Dec 05, 2012 7:31 am
by 1farmall95cub0
hi, my neighbor up the road has asked me if i will work on a lo boy for them, he said one day a few summers ago he was driving it across the yard, and it just up and quit on him, as far as i know they left it sit and havent done anything to it, so my question is what should i check first? i havent seen the tractor, dont have a clue what is wrong with it, will find out this sunday, thanks

Re: working on a lo boy soon

Posted: Wed Dec 05, 2012 8:01 am
by cub47
When I get a cub in that hasn't run in years, I always start out with these items and then go from there if needed:

-tune up with new plugs, wires, distributor cap, points, condensor (possibly the rotor also)
-check condition of wiring and grounds
-check timing
-clean or rebuild carburetor
-check for any debris in the gas tank
-compression checks

Re: working on a lo boy soon

Posted: Wed Dec 05, 2012 8:31 am
by Eugene
Note: Do not spend any money on the machine. Except a few dollars to pressure spray it.

See if engine is stuck. Pressure spray entire tractor. Let dry. Inspect tractor's exterior for obvious problems.

Providing engine not stuck. Prime oil pump. Check for oil in crank case. Install battery borrowed from other machine, clean all connections, see if battery cranks over engine.

Compression tests. Compression tests will determine next course of action.

My order is usually; compression, ignition, fuel.

Re: working on a lo boy soon

Posted: Wed Dec 05, 2012 8:34 am
by Boss Hog
I do not see that many cubs that need wires on them, if they are copper and rats have not been eating at them. you can file the points to make sure it is firing, take the main jet out and clean it. Drain any gas that is in it out. clean the fuel bowl. make sure you have a good flow at the carb, prime the oil pump.
and go from there.
It is easy to spend other folks money. Treat it as if it is yours
Boss

Re: working on a lo boy soon

Posted: Wed Dec 05, 2012 8:36 am
by Boss Hog
Eugene is faster than me :D

Re: working on a lo boy soon

Posted: Wed Dec 05, 2012 1:56 pm
by ntrenn
The pros have spoken...
I'm in the don't spend money until you have to camp. Borrow a battery - I live off borrowed batteries.
See if it cranks....
Feed it some gas
Get it some spark.

If it's not stuck, it's probably something super easy - like coil, condenser, or plugged fuel feed. Points/condenser set from the dealer is only about $15. Coil will cost you $50 or more.

Re: working on a lo boy soon

Posted: Wed Dec 05, 2012 5:46 pm
by beaconlight
First think what could have it to quit a few years back. First and most popular is plugged fuel. The sediment bowl, its screen, the screen at the fuel inlet of the carb (if it still has one). The mail jet (the brass hex sticking out the side of the carb bowl) plugs easily too. take it out and poke it out with a soft copper wire and the blow it out with compressed air. So far you have only sprung for a new gasket for the sediment bowl. You could even skip that step by putting fuel in the tank and then with the fuel valve under the sediment bowl turned on remove the main jet. You should get a steady stream of fuel. It shouldn't start and then drop off to a drip. Replace the jet I catch the fuel in an empty can so it doesn't get all over the place.
Next file the points as Boss says and check that the small metal tab is on the end of the rotor. I have had 2 with the rivets rotted and fall off on Farmall C's. I say check that for a cub and a C use the same rotor. After these are done try to start the Cub. If it starts you are OK If not let us know and we will take you further down the line.

I am basically cheap and trouble shoot as cheaply as I can. If you notice I haven't forced you to spent any more than for fuel so far and possibly for a gasket.

Re: working on a lo boy soon

Posted: Wed Dec 05, 2012 6:06 pm
by cub47
Getting a tractor to run is one thing, but to run well is another, and sometimes takes more than basics.

I guess you will have to see what your neighbor is expecting when he gets it back, but for about fifty bucks you could do a complete tuneup. Would save any you any future calls or problems in the near future.

Re: working on a lo boy soon

Posted: Wed Dec 05, 2012 8:16 pm
by 1farmall95cub0
well when the guy was telling me about it, i was thinking the coil may of went bad, but thanks for the other ideas of where to go, ill keep you guys posted when i bring it home

Re: working on a lo boy soon

Posted: Wed Dec 05, 2012 8:53 pm
by beaconlight
Generally but not all the time a coil may go bad while running as it heats up and then after an hour or so after it cools down it will let the tractor run again till it heats again. That said they do go flat out bad at times too.
Another question is does the starter turn the engine over?

working on a cub lowboy

Posted: Sun Dec 09, 2012 3:20 pm
by 1farmall95cub0
hi, im working on a cub loboy 154 for my neighbor, he had said it had just quit on them about to years ago, and they pushed it in the shed and didnt touch it, i have it under the shed now, with the battery charger on, it turns over, what would you guys do first if you were in my postion? gonna check the fuse and pull the carburator off to clean it tonight, any suggestions? thanks

Re: working on a cub lowboy

Posted: Sun Dec 09, 2012 3:26 pm
by RaymondDurban
Since the engine is the same as a regular Cub, the same steps apply.
-prime the oil pump
-ignition/timing
-compression
-fuel

To get it moving after the engine runs, the drive train is significantly different and will require a somewhat different approach.

Re: working on a lo boy soon

Posted: Sun Dec 09, 2012 4:47 pm
by 1farmall95cub0
ok, i have it under the shed now, its a 154 loboy, isnt frozen up, im in the process of cleaning the carburator, it was pretty bad, also posted a form similar to this in the loboy section

Re: working on a lo boy soon

Posted: Wed Dec 12, 2012 9:33 pm
by 1farmall95cub0
well i got it running, cleaned the carb all up, cleaned air filter, a new o ring in the carb gas line, and a little bit of starting fluid and she fired right up! took it back to the neighbors tonight and they were very greatfull, im glad i could help them out