Cub 154 clutch question

Tue Apr 17, 2007 8:52 pm

Per my earlier post, I have the trans out of my 154.

I want to replace the clutch while I have it apart. from checking the suppliers listed on the site, there seems to be 2 different clutches. Auburn and rockford. but the replacement clutch seems to be able to fit either set up. also the parts manual shows a 2 piece unit and the parts suppliers have a one piece.

can anyone shed some light on what direction to go?

Also is there an adjustment or setting for the pressure plate fingers? or do I just remove and re-install at the same placement.


Thanks again

Dave

Re: Cub 154 clutch question

Tue Apr 17, 2007 9:06 pm

Country:
country wrote:Per my earlier post, I have the trans out of my 154.

I want to replace the clutch while I have it apart. from checking the suppliers listed on the site, there seems to be 2 different clutches. Auburn and rockford. but the replacement clutch seems to be able to fit either set up. also the parts manual shows a 2 piece unit and the parts suppliers have a one piece.

can anyone shed some light on what direction to go?

Also is there an adjustment or setting for the pressure plate fingers? or do I just remove and re-install at the same placement.


Thanks again

Dave


Which Parts Manual are you looking in? I certainly hope it is the TC-131 Parts Catalog. The parts breakdown that you need I think would be found on TC-131 - Parts Catalog - Revision 8 - Power Train - Page 05

Image

Image
CUB IH LO BOY TRACTOR 154 CLUTCH PLATE 184 185
and
Image
CUB IH LO BOY TRACTOR 154 CLUTCH PRESSURE PLATE 184 185

Cub 154 clutch question

Tue Apr 17, 2007 9:11 pm

Rudi

that is what the clutch looks like and that is the parts manual link I was using

here is what I found, is it correct?

http://www.tmtractor.com/new/cl/521fp.htm

Dave

Tue Apr 17, 2007 9:15 pm

no, that is not the correct clutch disk for your cub, that is for the stnadard cub, not the number series.

Tue Apr 17, 2007 9:16 pm

You are looking at the offset cub / cub lo-boy clutch disc on TM's site. That is different from your 154 lo-boy clutch.

Cub 154 clutch question

Tue Apr 17, 2007 9:21 pm

can you point me in the right direction?

Tue Apr 17, 2007 9:41 pm

Call Bermuda Ken at Carter & Gruenewald. He will have what you need.
Website is http://www.cngco.com
800 # is on the website.

Wed Apr 18, 2007 5:21 am

Thanks

I will try them today