3260 mower hitch arms

[seahaul]

I have an IH 3260 mower but am missing the arms that attach it to a LoBoy 184. I have the large "H" shaped arm that bolts to the rear of the tractor but missing the three short flat arms that attach this H arm to the rockshaft.
Efforts to locate those three arms have been unsuccessful.
If anyone has a 3260 with all the right pieces, could you give me the lengths of those three pieces and the distance between the holes? A parts diagram identifies these as parts #11, #12, and #13.
Thanks,
Charlie

[Eugene]

Post a link to the photos of the mower's part's diagram.

I have a 3260 mounted on a 154. It will be a few days before I can measure up the linkage.

8:03 PM. Edit. Charlie. If you have manuals for Numbered Cub implements, please let the board members know. Manuals are hard to find and I'm sure we would appreciate having them available on this site.

I looked through my Farmall/IH manuals and do not have a parts manual for the 3260, nor could I find one on this site.

[BigBill]

Your looking for the two arms that lift the deck? These also attach the larger H arm from the rear final drives to the lift arms.

[Eugene]

I looked at the deck lifting linkage on my 3260 yesterday. There are 4 parts to the lifting linkage, on each side of the tractor, connecting the deck to the rock shaft.

Need parts diagram with numbers indicating needed pieces.

[BigBill]

I’ll have to look for my manuals. But my 154 is closeby.

Brain fade there’s three links on each side two have slots.

[Eugene]

I’ll have to look for my manuals. But my 154 is close by. Brain fade there’s three links on each side two have slots.

On my 3260 there is a bar bolted to the rockshaft which I counted as the fourth link.

[seahaul]

I don't have a parts manual but found a diagram on Messicks website at "https://www.messicks.com/cc/117410" under Cub Cadet 3260 mower hitch parts.
I need only the 3 flat bars on each side (#11, #12, and #13). I have the large "H" shaped piece and the yokes that connect directly to the deck.
If you could give me the length of these 3 pieces and the distance between holes, I can fabricate them. I think one of these may actually have a slot, if so need length of the slot.
Many thanks.
Charlie

[Don McCombs]

https://www.messicks.com/cc/117410?sectionId=263761&diagramId=801075

[BigBill]

I’ll have to look for my manuals. But my 154 is close by. Brain fade there’s three links on each side two have slots.

On my 3260 there is a bar bolted to the rockshaft which I counted as the fourth link.

Yup four links