Cub vs Cadet Transmission - Have a Question

A

AL Farmall Boy

501 Club
Do the cadet transmissions have a hole where the PTO shift lever goes on a regular Cub tractor? If so, was the hole plugged or just left open? I am needing a plug for the hole in question.
 
Just found this on the CASE/IH site under the 154 loboy section. Looks like it is a 11/16 expansion(?) plug. Number 16 in the picture. Where might I pick one of these up? THANKS!
 

Attachments

  • cub trans.JPG
    cub trans.JPG
    29.5 KB · Views: 471
AL Farmall Boy":hhhl9oh9 said:
Just found this on the CASE/IH site under the 154 loboy section. Looks like it is a 11/16 expansion(?) plug. Number 16 in the picture. Where might I pick one of these up? THANKS!
Click to expand...
Try NAPA. Same thing as a "freeze" plug in an engine block. TM is on holiday otherwise they probably stock them. Install it with the cup facing out. Give the center a rap with a hammer and punch and it will expand and seal the opening.
 
You must log in or register to reply here.
Back
Top