Page 1 of 1

BN not charging

Posted: Mon Nov 21, 2011 9:38 pm
by adamscub
I'm pretty sure that my '46 BN is not charging. The amp meter never moves to the charging side, and the new 6-volt battery has gradually run down. The needle on the meter only moves if the lights are turned on, and that is to the discharge side.

How do you go about addressing this charging issue? Where do you begin?

Thank you.

Adam

Re: BN not charging

Posted: Mon Nov 21, 2011 9:44 pm
by Bigdog
Just like you do on the cub - start in the middle and see which way you have to go.
Take a jumper wire and jumper the F terminal on the generator to ground. If it charges then, your generator is OK - the problem lies with the regulator / cutout or the associated wiring. If it does not charge the problem is with the generator.

Re: BN not charging

Posted: Tue Dec 13, 2011 11:17 am
by oldtractors
Try pulling the cover off of the voltage regulator.Take a emory board like you use to file you fingernails run it between the contact points inside the regulator without a lot of pressure. Check for burn marks on the points. Afterward, leave the cover off and start it . The points sometimes sticks. Check the guage to see if its charging. If not the generator brushes are worn. They are not hard to change as the whole unit is simple design.. They use AC Delco Generator brushes, I bought mine at Napa.

Re: BN not charging

Posted: Tue Dec 13, 2011 11:45 am
by Don McCombs
Try the simple stuff first. Have you tried repolarizing?

Re: BN not charging

Posted: Tue Dec 13, 2011 12:05 pm
by Bigdog
oldtractors wrote:Try pulling the cover off of the voltage regulator.Take a emory board like you use to file you fingernails run it between the contact points inside the regulator without a lot of pressure. Check for burn marks on the points. Afterward, leave the cover off and start it . The points sometimes sticks. Check the guage to see if its charging. If not the generator brushes are worn. They are not hard to change as the whole unit is simple design.. They use AC Delco Generator brushes, I bought mine at Napa.


I prefer to use a point file rather than sandpaper or emery boards - the leave a gritty residue.