Farmall Cub

Recently aquired a 42 H
fourth gear has 2 broke teeth on counter shaft
have the to sliding gears out need to get the lower countershaft out have it loose bearings out etc , book says to lift right out, with the large gear in place it will not come out of the tranny.
anybody been that far into the tranny , to help
I know the gears are pressed and keyed , appears I will have to pull the front gear, any help would be appreciated

Phil

I will be no help on this Phil.Mine works great at the moment and I hope it stays that way.Much differnt than your M??? Good luck.Kevin

I talked to Tina Hines at Hines Equipment in Delta Ohio
She said it does come out as one unit , minus the bearings , it is just takes some patience.
IHC was ahead of the times , the puzzles that will only come apart one way , the horseshoes and chain, 2 bent nail things ,chinese puzzle boxes,etc.
Phil

Got the counter shaft out, found that the front gear was to far forward had to be tapped back on shaft ,came right out.
as a complete assy
Phil