Page 1 of 1

torque for rod bearings

Posted: Tue Dec 04, 2007 2:01 pm
by john2189
anyone know what the torque is for the rod bearings on an H motor ?

John

Posted: Tue Dec 04, 2007 4:30 pm
by Bob Underwood
Service Manual calls for 55 ft lb on an M. I doubt if there would be much difference. Book does say the bolts are 7/16.
Bob

Posted: Tue Dec 04, 2007 4:40 pm
by Cub-Bud
According to the I&T manual, connecting rod bolt torque for an H should be 40 ft. lbs. Main bearing bolts should be torqued to 75 ft. lbs.

Posted: Tue Dec 04, 2007 10:04 pm
by john2189
thanks guys

Posted: Tue Dec 04, 2007 11:16 pm
by WKPoor
Goodandtight!!! Did you wire your mains like you should????

Posted: Wed Dec 05, 2007 5:23 pm
by john2189
yes, they are wired