Page 1 of 1

H fan belt

Posted: Wed Jan 24, 2007 9:00 pm
by bear4work
How do you tighten the fan belt and the one going to the generator on an H? Thanks for any help. 8)

Posted: Wed Jan 24, 2007 9:09 pm
by Bigdog
The water pump pulley on the H is a variable width pulley. There is a setscrew in the side of the pulley. Loosen it and use a soft drift to tighten or close up the gap in the pulley halves.
I believe the generator belt is tightened by the generator position.

Posted: Wed Jan 24, 2007 9:47 pm
by John *.?-!.* cub owner
I don't know about later ones, but earlier H had an adjustable pulley on generator also.

Posted: Thu Jan 25, 2007 6:22 pm
by SONNY
You are both right, but you forgot to tell about the sheves are usually rusted shut and are VERY easily broken,---may be awfully hard to find nowdays, as most of them broke because no-one ever lubed them and worked them as part of normal tractor maint.!! thanks; sonny

Posted: Thu Jan 25, 2007 8:38 pm
by bear4work
Thanks guys for all the info. I will look further into this (carefully).