All other non-specific model Farmall / IH / CASE tractors. (Catch-All)
Moderator: Team Cub
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
4 posts • Page 1 of 1
I have a Farmall 200 that has an unusual wide front end. Rather than the wide front that was used on the Super C, 200 and 230, this wide front is like the wide front that was introduced on the 240. The belly casting and front end has what appears to be experimental part numbers. I am not sure if the front end parts will interchange with the parts for the 240 wide front. But they do look the same except for the part numbers.
I bought the tractor many years ago in Ohio at an auction, The auction sale bill included information about the farm having been connected with International Harvester. It was this connection and the 200 that caused me to go to the auction. The buildings on the farm were some of the best I have seen. There was a fast hitch mower on the tractor as well as a carry-all and other tools. I bought the tractor with the mower and the carry-all. There were other tools for the 200 that I now wish that I had bought.
When I bought the tractor it had a spun main bearing and a damaged main bearing journal. Unfortunately at the time I was under some pressure to make room in the shop and could not find a way to get the block repaired quickly, reliably and correctly. I also could not find a good correct block quickly enough so we used a C123 from a stationary engine. While the tractor runs like a new tractor, I have never liked the fact that the block is not right. The missing bell housing bolt is a constant reminder. Does anyone know where I could get the mains on the original block repaired? I would like to return to tractor to as original as possible.
A second question is about tires. The tractor has what are probably 3 original tires and one 11.2 X 36 Goodyear Traction Torque that looks new. I have been looking for a matching traction torque for many years and would much appreciate it if anyone knows where I can find one. The 3 originals have a lot of wear left but will need to be replaced because of cracking and age.
Tom has pm'd me and asked about the axle on my 404 and had questions about a 200 he has. He sent me some pix but I couldn't help him. I found this old thread he had started but nobody had responded to it. Since I have the pix I thought I would toss them out here and see if anybody could shed some light his questions now that we have photos.
Sea salt is healthier only because it gets stuck in the holes of the shaker and you can't actually put it on your food.
Barnyard Bash CubFest May 30th - May 31st, 2014
Click here for info.
This wide front setup looks to be the same as a Farmall 340 that I use to own. I never saw another one like it. It was a row crop type, but with a wide front instead of the usual tricycle configuration. Most other 340's that I have seen also came with the RH side mounted remote hydraulic control valves and a TA. Mine had neither. I was told sometime during the 20 years that I owned it, that it was setup this way for mowing highway right of ways.
1947 Cub S/N 9216 (My Dad's "Uncle Bob")
We make a living by what we get, but we make a life by what we give......Winston Churchill
4 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest