Page 1 of 1

super c touch control

Posted: Wed Apr 05, 2006 9:45 pm
by dw
How hard is it too plumb in 2 hydralic hoses in to the touch control? I have seen pictures of this done on c models, but cannot make out the actual details. Whitch line is the supply and whitch is the return to tank?

Posted: Thu Apr 06, 2006 6:51 pm
by WKPoor
I believe its done with the same aux. block used on the Cub touch control but I have not actually done it myself.

Posted: Thu Apr 06, 2006 7:33 pm
by jostev
Well, if you have a Fast hitch, it will be much easier I think, my C has the same valve setup with a loader that our Super C has with the fast hitch, if I get a chance tomorrow, I will take some pics and find out....

Johnny

Posted: Thu Apr 06, 2006 10:36 pm
by LiL' Red
The smaller line of the two is pressure, the larger is return to pump. You could run from the existing plugs in the manifold block that attaches to the lift unit, but if you are after volume you will neeed to install a block or find a used remote valve for C SuperC 200.