144 High-Clearance cultivator
Posted: Thu Aug 08, 2013 9:50 pm
Last week the JD 900 HC we used where I work turned red (electrical fire near the full plastic fuel tank). Soooooo...
We are trying to fit one of the HC 140's with cultivators. Unfortunately we only have the cultivators for a regular 140. I haven't seen a HC 140 with cultivators for 15 years and my memory isn't that long.
I assume
1.The universal mounting frame and rear tool bars are the same
2.The front "frame bars" that slide into the steering gear housing are the only difference in the front. HC being "swooped down and extend further out (longer)
3.The rear tool bar bearings and lift rods are the only difference in the rear.
4.The rear tool bars and front mounting frame are 6" lower.
Questions
1. Are any of my assumptions wrong (or are any of them right)
2. How much further out does the "down swooped"front bar frames extend for the Universal mounting frames front bearing mount and top parallel round bars to clear.
3. Is there a good parts list showing these parts. or better measurements--- for some reason my PC locks up if I try to look for this kind of stuff -- but will follow a link HONEST I'm not enlisting others to do my legwork because I'm to lazy to look.
4. Rather than cut and weld/ heat and bend does anybody have any parts for sale?
Thank you
We are trying to fit one of the HC 140's with cultivators. Unfortunately we only have the cultivators for a regular 140. I haven't seen a HC 140 with cultivators for 15 years and my memory isn't that long.
I assume
1.The universal mounting frame and rear tool bars are the same
2.The front "frame bars" that slide into the steering gear housing are the only difference in the front. HC being "swooped down and extend further out (longer)
3.The rear tool bar bearings and lift rods are the only difference in the rear.
4.The rear tool bars and front mounting frame are 6" lower.
Questions
1. Are any of my assumptions wrong (or are any of them right)
2. How much further out does the "down swooped"front bar frames extend for the Universal mounting frames front bearing mount and top parallel round bars to clear.
3. Is there a good parts list showing these parts. or better measurements--- for some reason my PC locks up if I try to look for this kind of stuff -- but will follow a link HONEST I'm not enlisting others to do my legwork because I'm to lazy to look.
4. Rather than cut and weld/ heat and bend does anybody have any parts for sale?
Thank you