100-140 Fast Hitch manual?

[Super A]

Was there a separate operator's manual for the one point fast hitch on the 100-130-140? If so does anyone have a copy they could email me?

thanks,
Al

[Rudi]

Al:

I checked everything I have that is scanned but came up empty. If you acquire one that has been scanned let me know please.

[Brendan In NC]

AL i dont believe IH sold a manual for the fast hitch. the hitch is easy to use when setting a plow you adjust the lever till the plow sits at a angle leave the lock pin on the cross bar out so it moves back an fourth an use the front lift whit the front arm to the fast hitch to set the plow pointed at the ground so it digs in instead of sliding across the ground an when you hitch to another piece of equipment just lower the lift till it at the same height as you disk plow or blade or mower is an just back up it snaps right in an when your unhooking have a rope tided to the lock coupler so it easier to unhook whitout someone pulling it.

hope all this helps good luck whit it all

[Super A]

AL i dont believe IH sold a manual for the fast hitch. the hitch is easy to use when setting a plow you adjust the lever till the plow sits at a angle leave the lock pin on the cross bar out so it moves back an fourth an use the front lift whit the front arm to the fast hitch to set the plow pointed at the ground so it digs in instead of sliding across the ground an when you hitch to another piece of equipment just lower the lift till it at the same height as you disk plow or blade or mower is an just back up it snaps right in an when your unhooking have a rope tided to the lock coupler so it easier to unhook whitout someone pulling it.

hope all this helps good luck whit it all

Thanks! I wasn't sure if they did a manual for it or not. I will be picking up a hitch for my "new" Super A in April at Boss Hog's. Then I want to find a IH 120 or 122 fast hitch disk for it....

Al

[donut]

i have a 5 ft. disk for my 140.they are a regular 3 pt . hook up. the guy i bought my tractor from bought a prong and welded it it on. it works fine , and the 3 pt. hook up is still on it!