Farmall Cub

Who has experience with these? Looks like mine is leaking around the piston sleeves. I thought I found a kit on line that looked like a gasket package but I didn't know what I was looking at. Also the sleeves look kinda rough to but I don't want to clean it up to take a better look for fear of making it worse but the kit didn't seem to have these. It's tolerable but annoying at the moment.

Are you talking about the Touch Control Unit itself? If so it is a fairly easy rebuild.

Yes is there a rebuild kit? Is the number stamped on the right hand side the part number? I'm glad to hear its easy.

No complete kit that I know of, but all the parts are available as of 6 months ago from Case/IH, you will need the # off the unit I have seen some SA units on a 140

excellent. thanks. hopefully i'll get it figure out. when you say it's easy to rebuild could it be done from start to finish in a day?

Takes about 4 hours after it is on the bench

getting all the O rings will be the hard part you need a good parts man and you may need to replace the little plastic bullets if they are worn

Excellent just found another post from earlier this year that helped a lot as well. I feel less intimidated after looking through it. Looks like a worthwhile endeavor.