Hydraulic pump

Sat Aug 03, 2013 10:10 am

Who has experience with these? Looks like mine is leaking around the piston sleeves. I thought I found a kit on line that looked like a gasket package but I didn't know what I was looking at. Also the sleeves look kinda rough to but I don't want to clean it up to take a better look for fear of making it worse but the kit didn't seem to have these. It's tolerable but annoying at the moment.

Re: Hydraulic pump

Sat Aug 03, 2013 7:09 pm

Are you talking about the Touch Control Unit itself? If so it is a fairly easy rebuild.

Re: Hydraulic pump

Sun Aug 04, 2013 6:38 am

Yes is there a rebuild kit? Is the number stamped on the right hand side the part number? I'm glad to hear its easy.

Re: Hydraulic pump

Sun Aug 04, 2013 7:26 am

No complete kit that I know of, but all the parts are available as of 6 months ago from Case/IH, you will need the # off the unit I have seen some SA units on a 140

Re: Hydraulic pump

Sun Aug 04, 2013 9:17 am

excellent. thanks. hopefully i'll get it figure out. when you say it's easy to rebuild could it be done from start to finish in a day?

Re: Hydraulic pump

Sun Aug 04, 2013 12:50 pm

Takes about 4 hours after it is on the bench

Re: Hydraulic pump

Sun Aug 04, 2013 12:52 pm

getting all the O rings will be the hard part you need a good parts man and you may need to replace the little plastic bullets if they are worn

Re: Hydraulic pump

Mon Aug 05, 2013 7:57 pm

Excellent just found another post from earlier this year that helped a lot as well. I feel less intimidated after looking through it. Looks like a worthwhile endeavor.