Thu Jun 23, 2011 10:45 pm
Pulled mine off bearing looks good but leaking a little around outside of shaft should oil seal fix this problem? What else do i need to do since i have it off?
Thu Jun 23, 2011 10:49 pm
Is there suppose to be a gasket behind the plate on the right side where the oil seal is at
You do not have the required permissions to view the files attached to this post.
Thu Jun 23, 2011 11:26 pm
If you remove the retainer, #48, you'll need to replace the gasket #47. Don't think it was necessary, though, when just replacing the seal #49.http://www.cleancomputes.com/Cub/Super%20A%20-%20Super%20AV/TC-39B%20Parts%20Catalog/Page%20268.jpg
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.