Hydraulic shenanigans :?

Farmall Super A, AV, 1939 - 1954

Moderator: Team Cub

Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.

Hydraulic shenanigans :?

Postby allenlook » Mon Apr 03, 2006 8:19 am

Gotta get my brain wrapped around these hydraulic concepts...

The Henderson loader has its own control, just one lever that when pulled back will raise it, and when pushed forward will let it down of its own accord.

Sometimes, not always, when I move one of the Touch Control levers, (I think it's the one on the left) the loader will start to raise, and it will keep going even if I put the Touch Control lever back to its original position or move the Henderson lever to try to lower it! What gives?

The Henderson control is attached to the Touch Control unit by being tapped into the hydraulic manifold through the rearmost tap and also underneath the manifold. As in this picture...

Image
Searchable Cub Parts Database and Manual Galleries at www.farmallcub.info - Computerized Carving at www.bitcarving.com
User avatar
allenlook
Cub Pro
Cub Pro
 
Posts: 1795
Joined: Sat Jul 31, 2004 10:37 pm
Location: NY, Saratoga Springs
Zip Code: 12020

Postby Matt Kirsch » Mon Apr 10, 2006 2:01 pm

The control valve for the loader is leaking internally. That's the only possible explanation. There should be no other way for fluid to get into the cylinders except through the valve. If that's the case, it must be leaking.

One of those hoses from the hydraulic manifold should go to the IN port on the loader control valve, and the other to the OUT port. One of the "work" ports on the valve should go to a T, which in turn should to to the bottom of each cylinder. The other work port should be plugged, though it may be connected to the tops of the cylinders through another T if you have two-way hydraulics on the loader. There should be no other connections. If there are, it's plumbed incorrectly.
Matt Kirsch
501 Club
501 Club
 
Posts: 3181
Joined: Tue Jun 08, 2004 3:04 pm
Location: Rochester, NY
Zip Code: 00000
Circle of Safety Award
Circle of Safety: Y

Postby allenlook » Mon Apr 10, 2006 6:05 pm

Aha!

I think it IS plumbed incorrectly from your description... I'll check it tomorrow and see - thanks for your response!
Searchable Cub Parts Database and Manual Galleries at www.farmallcub.info - Computerized Carving at www.bitcarving.com
User avatar
allenlook
Cub Pro
Cub Pro
 
Posts: 1795
Joined: Sat Jul 31, 2004 10:37 pm
Location: NY, Saratoga Springs
Zip Code: 12020


Return to Farmall A, Super A, AV

Who is online

Users browsing this forum: No registered users and 2 guests