Page 1 of 1

How To Make A Tear Drop Lens Storage Case

Posted: Sat Sep 15, 2007 8:03 pm
by Rudi
One of the problems that I have is that it is difficult to safely store breakable Cub Parts in a Cabinet Shop :roll: :wink: :shock: :big smile: I currently use 20 Litre or 5 US Gallon Square Plastic Laundry Detergent Pails to store much of my parts, but some stuff just doesn't fit well into parts boxes that fit into these pails.

Such is the problem with the Guide Lens for the Tear Drop Lights. They are expensive to replace with repros, and almost impossible to find as originals :shock: So here is my solution to prevent breakage.

    How To Make A Tear Drop Lens Storage Case
    • Save a 50 CD Storage Spindle Tower Case. Make sure you keep the little foam washers and the clear CD blanks.
      Image

    • Cut off the centre spindle on the band saw or with a Flush Cut Hand Saw

      Image
    • Take 5 Foam Spacers and place between the base and the first lens.

      Image
    • Place and additonal 2 Foam Spacers between each lens. I have 3 for storage, but you can fit up to 5 Lenses in one Spindle Tower Case.

      Image
    • Replace the Spindle Tower Case Cover and put your Lenses safely away in storage.

      Image