poor mans filler flange straightening tool

Splitting stand, mounting stands, etc, etc.

Moderator: Team Cub

brewzalot
Cub Star!!
Cub Star!!
Posts: 371
Joined: Sat Jul 12, 2014 10:10 pm
Zip Code: 53105
Tractors Owned: '57 cub Loboy
'61 cub
Circle of Safety: Y
Location: Wisconsin, Burlington

poor mans filler flange straightening tool

Postby brewzalot » Sat Aug 08, 2015 8:09 pm

My gas tank filler flange wasn't terrible but did need some straightening. I came up with this idea to tweak it, very similar to the expensive IH tool. But can be made by anyone with a welder and some scrap steel. The only trick is getting the right radius on the 2 welded on tabs, I used a pc. of 1/8" wall pipe that was very close to the size and hammered them to shape before welding. You do have to move it around the rim a few times to get it all. This worked out pretty good and didn't cost much.


DSCF6671 (640x478).jpg
Just a 2 pc. assembly with a 6"long pc. of 3/8 threaded rod and 2 nuts trapping the plate

DSCF6666 (640x412).jpg
Tip jig into tank

DSCF6669 (640x478).jpg
Move up into position and pull-hold upward

DSCF6668 (640x478).jpg
Put on top plate, washer, and spin a 3rd nut down snug. Tighten with wrench until it stops- loosen, reposition, and repeat.

  • Similar Topics
    Replies
    Views
    Last post

Return to “Specialty tools”

Who is online

Users browsing this forum: No registered users and 0 guests