Page 2 of 2

Re: Tube Bending

Posted: Thu Mar 19, 2009 10:31 pm
by dakcub
I found my bender.it's 3/8" here are a couple of pictures.....check them out.....I will post in a couple of days with pictures on how it works.

Image
Image
Robert (1 budlight from bed) Miller

Re: Tube Bending

Posted: Fri Jan 21, 2011 6:36 pm
by holman
Hi. In my time as a pipefitter, I bent miles of tubing offsets and multi runs. It takes time and practice. Sometimes you have to add the dia. other times subtract the dia. and sometimes add the space between the tubes your running. Where are you located? Buy extra and practice. Holman New Jersey

Re: Tube Bending

Posted: Sat Apr 02, 2011 11:47 pm
by fodman
i am also a pipefitter and tubeing & instrument fitter. from my experance you can get a good idea of how it's done from a book but ( BIG BUT ) you will have to bend alot of tubeing to get good at it. there are many trick's to the trade that take time to learn. you must measure correctly to start with, you will have to consider the take-out of fitting's used. if lines are to be run side-by-side you must plan your bend's and add or subtract the o.d. of each line ( if lines are touching each other ).alway start at one end of line and never reverse the bender unless you have to. alway's use the center to center measure to make your bends. use a speed square to check your bends and adjust as needed, you will have to go past the marks on the bender ( a little )as the tube will tend to spring back a little. some things are only learned by hands on experance! bend a coat hanger like you need the tube and look at it before you make each bend. use a sharpie marker to mark where you need line up the bender on the tube. here is the easy way to do it .....example...two bend's with center of bends 12" apart in a run of tubing...mark a tube with the sharpie where where you want the first bend,place tube in bender with sharpie mark at the the two zero's on bender lined up, bend your 90 , next measure from center of that bend and place a mark at 12" and line that mark up with the 0 dagree line again and bend another 90. you can do this also on 45's. this way you do not have to add or subtract for the radius of of the bend. do not reverse the bender when you do it this way. aint it easy. :) edit..the bender in the above photo has an L where on some benders there would be a 90, just depends on the brand of bender.

Re: Tube Bending

Posted: Sun Apr 03, 2011 8:56 am
by John *.?-!.* cub owner
One thing I learned while making gas lines for my cubs was that the brake lines from Autozone, or a nice black color and easier to bend than the ones from NAPA. By the same token, I think I would prefer brake lines made from the NAPA ones, but for gas lines, Autozone ones are good enough.

Re: Tube Bending

Posted: Fri Aug 19, 2011 7:53 am
by CPIII
This looks like a great tubing bending instruction manual from Swagelok.
http://www.swagelok.com/downloads/webcatalogs/EN/ms-13-43.pdf
I work for 16 years at a power plant so I have done a ton of tubing bending. It takes a good deal of practice to turn out really nice multi tubing runs.

Re: Tube Bending

Posted: Fri Aug 19, 2011 9:06 am
by Jim Becker
Here is another method shown on youtube.
http://www.youtube.com/watch?v=Zq-D4kOMz6Y