This could possibly be the Cub tip of the week, maybe tip of year.
The hardest part of sliding the pto shaft back in place, while aligning the shifter rod is shining a flashlight down in the fill hole and trying to look around the flashlight.
I made up a miniture drop cord using a mini light bulb. The bulb can be lowered down in the hole leaving only two small wires visible in the hole. The little 12 volt bulb illuminates all of the inside of the pto cavity. You can then see the end of both shafts, collar and the shifter lever all at the same time. What was taking me sometimes hours to install the shaft, now a very few minutes.
Splitting stand, mounting stands, etc, etc.
Moderator: Team Cub
1 post • Page 1 of 1
- 10+ Years
- Posts: 1684
- Joined: Tue Jul 18, 2006 9:55 pm
- Zip Code: 37087
- Tractors Owned: 1947 Cub S/N 9216
w/ C-22 Mower
1974 Cub S/N 244814
w/59 Woods Mower
Ford 3000 Gas S/N C375091 w/Bushhog QT2345 Loader & 6' Squealer Bushhog
and a Palomino Mare named GIGI
- Circle of Safety: Y
- Location: TN, Lebanon
"Courage is being scared to death-but saddling up anyway".......John Wayne
- Similar Topics
- Last post
Tue Aug 16, 2016 8:21 pm
Fri Oct 21, 2016 4:42 pm
Thu May 05, 2016 5:32 pm
Copper ground strap tear drop lights for reflector
by inairam » Fri Oct 05, 2018 6:27 am » in Farmall Cub
Fri Oct 05, 2018 6:27 am
Who is online
Users browsing this forum: No registered users and 0 guests