This is good stuff, spray several coates to each side.
Make sure that you put the gasket the correct side up.
After several head change attempts I have realized that it is best to leave the air cleaner and waterneck in place and remove the head with it on.
This is also a good time to put a new gasket on the waterneck, clean out the air cleaner, and replace the upper radiator hose.
Whether you are swapping heads or not I would leave the bolts in the head after loosening, then you don't have to worry about having the wrong length bolts in the wrong holes.
I took each bolt out wire brushed and copper coated then put it back into its respective hole.
Make sure to clean up any old gasket and sealent from the head and the block.
Use a torque wrench to progressively come up to the 45#'s
Make sure to cross pattern while tightening so that the force is spread as evenly as possible.
On this job I replace the cracked head with another used head that had been magna-fluxed and 'decked' or milled.
So far so good.
Take your time, have good tools, light and help and it will not be a difficult job.
Thackery Doug
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
How To Change A Head Gasket
-
- 10+ Years
- Posts: 490
- Joined: Wed Nov 23, 2005 2:53 pm
- Location: West Central Ohio
How To Change A Head Gasket
1953 Cub, Sickle Mower, 42" Mower, Cultivators, 189 Double Plow, 54 Blade, Grader Blade
1968 Lo-Boy w/1000 Loader, 1957 Lo-Boy w/FH, FH Disc, FH Potato Plow.
1968 Lo-Boy w/1000 Loader, 1957 Lo-Boy w/FH, FH Disc, FH Potato Plow.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 4
- 253
-
by pett3227b
Wed Nov 01, 2023 12:36 pm
-
- 7
- 465
-
by Clemsonfor
Mon Sep 13, 2021 4:57 pm
-
- 3
- 343
-
by Clemsonfor
Thu Feb 17, 2022 7:56 pm
-
- 5
- 295
-
by Leewebb7
Fri Feb 02, 2024 11:39 am
-
- 3
- 187
-
by cdahl383
Sun May 14, 2023 8:02 pm
Return to “Engine, Clutch, Transmission and Hydraulics”
Who is online
Users browsing this forum: No registered users and 0 guests