Take the carb off, take the inspection plate off. (also easier if you remove the manifold.)
Remove #1 sparkplug (the one closest to the radiator.)
Rotate engine till both valves in #1 close. Look in the hole. & the pointer is at the notch in the crank pulley. #1 is at TDC at this point.
Check clearance on 1, 2,3 & 5. Adjust to .015 clearance cold.
Rotate engine 360 degrees until #4 is at TDC.
Check clearance on 4, 6, 7, & 8. Also adjust to .015 cold clearance.
Repeat and double check everything.
Get a new gasket from TM (one of our sponsors) or use good sealant and install the cover plate.
Install the manifold (if removed), the carb and any spark plugs you took out.
It should now run much better without the clatter.
Good luck and keep posting.
Time saving tips to keep your Cub running smooth
Moderator: Team Cub
1 post • Page 1 of 1
- 10+ Years
- Posts: 2758
- Joined: Wed Apr 23, 2008 10:10 am
- Zip Code: 70401
- Tractors Owned: 3 barns full of Cubs and implements in various stages of disrepair
- Location: LA, Hammond
- Similar Topics
- Last post
Sat Feb 10, 2018 10:03 pm
by Jim Becker
Wed Jan 13, 2016 12:06 pm
by Crimson Tim
Wed Aug 17, 2016 12:36 pm
Thu Jul 27, 2017 9:34 pm
Thank you to all forum members or how to adjust the clutch p
by inairam » Mon May 30, 2016 11:06 am » in Farmall Cub
by Trent M
Mon May 30, 2016 11:45 am
Who is online
Users browsing this forum: No registered users and 1 guest