[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4493: ob_start(): output handler 'ob_gzhandler' conflicts with 'zlib output compression'
Farmall Cub • View topic - I will be installing an alternatior on this original cub

I will be installing an alternatior on this original cub

Sat Dec 24, 2011 11:38 pm

Image
Image
Image
Image
Image

I hope to be able to take pics as I go all of these are the before :D
I will update soon
Here I am using the original bracket
Image
The top bracket is one from Clint
Image
Image
As you can see I am using the old type fan with the small pulley
Image
here you can see the coil with the built in resister , be sure to hook the - side of the coil to the distributor.
Image
here you can see the new amp gauge and headlight switch
Image
you do not have to change them, but I am doing this for a customer and dont want any problems down the road. I also replaced the old fuse holder as I am re wiring it too.
Boss
Last edited by Boss Hog on Sun Jan 01, 2012 12:14 am, edited 2 times in total.

Re: I will be installing an alternatior on this original cub

Sun Dec 25, 2011 6:16 pm

I'll be watching Boss, be sure to tell them they no longer need the late model fan with the larger alt pulley.
When using the Napa # 213 401 1SW one wire alternator it kicks in at a lower RPM. :-:-):

Re: I will be installing an alternatior on this original cub

Sun Dec 25, 2011 7:01 pm

I had to do it on the LOWBOY,. The Generator was WHO KNOWS. The regulator was a very good collection of rust and the wiring was a rube Goldberg. Just cut the wiring out, Replaced with Alternator as well as replacing the Amp meter with a volt meter. Everything ran well and it charged with no problems. i am sure y'all will find it to work the same for you.

Re: I will be installing an alternatior on this original cub

Tue Dec 27, 2011 8:44 am

I installed a Chrysler ballast resistor instead of replacing the coil. I mounted the ballast resistor on the back side of the original coil, in the coil bracket mounting bolt hole. Took a longer bolt and a nut to replace the original shorter bolt. The ballast resistor is less expensive than replacing the coil.

I had to use a 20" belt. The generator had a 22" belt, which let the alternator hit the hood.

I replaced the original 20 amp IH amp meter with a 60 amp rated amp meter.

Alternator charges at just above low idle. At low idle, last notch on throttle, amp meter shows a slight discharge.