Post your introduction and "get to know me" information in this forum.
Mon Aug 06, 2012 11:54 am
I am restoring my Dad's old Farmall A that's been in storage for past 12 years. I got it running after putting in new plugs, wires, points, rotor and distributor cap last week. It's easy to crank and I won't even bother with a battery. Unfortunately the clutch seems to be stuck to the flywheel (possibly after setting up so long). Any ideas or help would be appreciated. Richard Bosart, Cuero, Texas
Mon Aug 06, 2012 1:22 pm
Rust will do that. Some people have had luck blocking the pedal down and spryaing brake cleaner on the clutch through the hand hole underneath.
Wed Aug 08, 2012 7:16 am
Richard, Welcome to the forum.
If you go over to the Farmall A section (viewforum.php?f=170
) and re post you will get more responses.
Again welcome and have fun on this great site.
Thu Aug 09, 2012 8:48 am
Thanks John, will try that this weekend.
Thu Aug 09, 2012 8:50 am
Thanks Mike, will do that. Looking forward to visiting with everyone.
Tue Aug 14, 2012 10:40 am
Hey John, Thanks for the advice Regarding the 1946 Farmall A with the stuck clutch plate. I blocked the clutch pedal down on Saturday like you said to do and sprayed the brake cleaner in the housing thru the inspection hole while my wife was cranking the engine slowly and let it set a day. When I returned on Monday, I put the tractor in gear and cranked the motor over and it didn't move, so I knew it had released. I unblocked the clutch, started it up and it ran like a top. Joining the club was worth it, just to get this information. Thanks again, Richard
richardbosart Posts: 5Joined: Sun Aug 05, 2012 11:01 am
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.