Post your introduction and "get to know me" information in this forum.
Tue Jun 19, 2012 11:49 am
Hello all I found this site looking for info on my 1949 Farmall Cub. My name is Morgan McCormick and I live in the smalltown of Verdigre, NE with my parents because I'm only 15. I have just started the buildup of the cub my dad bought a few years ago that has just sat. It ran good but burned oil because it smokes alot of blue. Please bare with me as I learn the tricks of the trade but this place looks to be full of info.
Tue Jun 19, 2012 12:46 pm
Welcome to the forum! Someone with a last name of McCormick, ...from Nebraska, can't get much better!
Looks like your "small town" of Verdigre, NE is straight north about an hour of the place I have that is between Albion and St. Edward.
Congratulations on your first Cub, should be a good father / son project, best of luck with it!
Ask away if you need any help,
Tue Jun 19, 2012 1:00 pm
Welcome aboard. Lots of informtion and help here ifn you need it.
Tue Jun 19, 2012 1:00 pm
Welcome, Morgan. Lots of help here.
Tue Jun 19, 2012 2:06 pm
Ya with the last name of McCormick I figured that I should get a tractor with my name on it. We drive through St. Edward and Albion on the way to my grandparents everytime we go there. Im going to try and get pics loaded in a bit.
Tue Jun 19, 2012 2:17 pm
Also have an old IH 200 manure spreader that was given to us and it just needed a floor, but now its just a junk holder.
Tue Jun 19, 2012 9:18 pm
Welcome aboard. Enjoy and check out the full site, especially Rudi's manuals under manuals at the top of each page. Lots of folks on here with lots of knowledge and always willing to help out.
Wed Jun 20, 2012 9:20 am
G'day to you and congrats
on taking on the rebuild. Hope you and your Dad get a lot of quality time together on this project. There is lots of help available here so ask away. Suggest you follow the links below and learn about your Cub from the Owner's Manual to the other resources available. Your manure spreader looks to be in roughly the same shape as my McCormick 100. Enjoy playing with the Cub and Spreader.
Wed Jun 20, 2012 9:45 am
Thanks for those links to Rudis manuals, those will help out alot. Dad tries to help as much as he can but is gone most of the day usually so I do alot of it myself but it is a great learning expierence. I'm trying to get some expierience so this fall I can rebuild that 390 ford motor sitting in the first pic. Thanks!
Wed Jun 20, 2012 1:17 pm
Welcome to the forum.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.