This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link:
Privacy Policy

NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.

Using Bob McCarty's Carb Gasket Template

All fuel related How To’s can be found here
User avatar
Dale Finch
10+ Years
10+ Years
Posts: 6643
Joined: Tue Apr 27, 2010 11:34 am
Zip Code: 27517
Tractors Owned: '51 Cub #140966 "Bruno" with Woods 59 mower
'55 Cub #187541 "Betty" with Fast Hitch
'55 Cub #190482 "Ben" with Woods 42 mower
'55 Cub #191739 "Bertha" with Woods 42 mower
'56 Cub #194370 "Boris" with Mott Flail mower
Circle of Safety: Y
Location: NC, Chapel Hill

Using Bob McCarty's Carb Gasket Template

Postby Dale Finch » Sat Oct 01, 2011 9:02 am

The following series of photos shows the steps for using Bob McCarty's Carburetor Template to make new body gaskets for your carburetor. You can find the posting for them at:
http://www.farmallcub.com/phpBB2/viewtopic.php?f=28&t=64485

1. Outline the template onto 1/16th" gasket material with pen or fine felt tip:
Image

2. Punch holes -
1/8" for idle tube and crescent ends
3/16" for bolt holes and float corners
5/16" for curve at edge of float hole
1 1/16" for venturi hole (or cut with knife)
Image

3. Cut crescent using template and cut float bowl sides with template or straightedge using the knife knife (utility or X-acto):
Image

4. Cut outside with knife and template or scissors. (NOTE: cut away drawn pen lines or gasket will be wider than wanted):
Image

5. Tools used:
Image

MANY THANKS to Bob for all his hard work!!
Last edited by Dale Finch on Sun Oct 02, 2011 7:06 pm, edited 1 time in total.
Dale Finch
Image
Circle of Safety

SPONSOR AD

Sponsor



Sponsor
 

Return to “Fuel”

Who is online

Users browsing this forum: No registered users and 2 guests