Main Jet Thread Repair

All fuel related How To’s can be found here

Moderators: Barnyard, Team Cub

Main Jet Thread Repair

Postby clodhopper » Wed Sep 14, 2011 8:07 pm

This is the heli coil I used to repair the stripped main jet hole in my carb. Its 1/4-28 thread. This repair is easier if you buy a complete kit. I picked up one on ebay for $22.00. The coils that came in the kit were just the right length for this repair. They are the same length as the threads on the jet.
carbjet1.jpg


Here, I measure the coil to see what size the outer hole must be to allow the coil to pass through.
carbjet2.jpg


Drilling the outer hole. I used a 3/8 bit. Be careful not to drill beyond the fuel bowl!!
carbjet3.jpg


Here, I am tapping the hole to accept the coil. I didnt have to drill the carb body out because it is soft metal, and it was CLEANLY stripped of threads. You will also note the finish nail in the top of the carb. I used it as a depth gauge reference for the tap.The tap, while it says 1/4-28 is not a standard tap, but a STI (Standard Thread Insert) Tap. It is made specifically for the coil size OD.
carbjet4.jpg


And here I an installing the coil with the installation tool that came in the kit. Once I got it through the outer hole, I dripped 1 drop of red loctite on the coil and screwed it in place. The tricky part is removing the tang after install. I used an old drill bit just smaller than the id of the coil, dropped in the hole backward,and popped it off with a small hammer. I tapped it on the workbench and it fell out (finally). Once done, let the loctite set overnight, and just reassemble the carb and your set!
carbjet5.jpg
I'll be drinking that free bubble up, and eatin that rainbow stew.
http://www.builditnc.com
User avatar
clodhopper
501 Club
501 Club
 
Posts: 724
Joined: Sat May 07, 2011 8:20 pm
Zip Code: 27526
Tractors Owned: 1950 Cub Demo
1978 Cub Cadet 1650
cub 193 plow
cub 174 planter
cub sidedresser
cub 144 cultivator
cadet 50a deck
60A grader blade
Circle of Safety Award
Circle of Safety: Y

Return to Fuel

Who is online

Users browsing this forum: No registered users and 1 guest