The underslung pipes are usually always rusted and pitted , but you can make yours slicker than new.
First clean and remove all rust. I like to use a coarse sanding sponge and some Krud Kutter. Then prime with rust arrester.
Then brush on a good heavy coat of Por 15 manifold coating, let dry and sand off as much as you can with medium paper.
This will almost level the surface. If not, repeat until you are satisfied with the finish. I used three coats of Por 15.
When you're happy with the finish, spray on a coat or two of high temp clear coat.
Works well on manifolds and mufflers too.
The Por 15 and high temp clear coat are available at most automotive paint stores.
Time saving tips to keep your Cub running smooth
Moderators: Barnyard, Team Cub
1 post • Page 1 of 1
- Cub Pro
- Posts: 1951
- Joined: Tue Mar 11, 2003 9:16 pm
- Zip Code: 85615
- Tractors Owned: 6 Cubs and no mas.
1947 Circle series Farmall Cub with Armstrong lift, belt pulley, 5"rims 6" tires, SN 563
1949 Farmall Cub with high crop option and hydraulics
1955 Farmall Cub with fast hitch
1955 International Cub Loboy with fast hitch
1957 Farmall Cub with fast hitch
1959 Farmall Cub with fast hitch
- Location: way high up in the Huachuca Mt. at the bottom of a deep dark canyon
"The time you spend making sure you are safe is probably the most productive time you can spend!"
- Similar Topics
- Last post
Wed Jun 21, 2017 7:56 am
by bob in CT
Fri Jan 30, 2015 2:05 pm
by Bill Hudson
Fri Feb 10, 2017 9:48 am
Who is online
Users browsing this forum: balloonatic5 and 1 guest