He at some point "converted" the bar to three point connection.
So I decided to refurbish all the attachments and build new arms and lifting eye on toolbar.
The cub still had the guide angles and connection plates for the toolbar... parts 4,5 & 6 from manual.
In order to get toolbar arms and lifting eye plates cut on burning table, I had to draw them up. So while I was at it I went
ahead and drew up everything. Thought I would share in case any one else needed it.
See attachment below... Document has two sheets, SH1 is part 3 and SH2 is parts 4,5 & 6.
If any one needs the actual AutoCAD file, PM me with request and your email address and I can send to you.
