2016 Project help needed - a narrower cub

[staninlowerAL]

For all practical purposes, the adjustable set at full width are the same as the one piece wheels. I don't know if there is clearance on the 154 to set them any narrower, probably not without other modifications.

Mine has about 5 inches clearance between the inside of the turf tire and the 154 rear fender. I can get a picture if you need it. Stan

[tractordad]

For all practical purposes, the adjustable set at full width are the same as the one piece wheels. I don't know if there is clearance on the 154 to set them any narrower, probably not without other modifications.

Mine has about 5 inches clearance between the inside of the turf tire and the 154 rear fender. I can get a picture if you need it. Stan

Stan,

Thanks, that may help.
Gary

[Rob in NH]

my son uses a kubota 2320 narrow with a 42 inch brush hog.

[tractordad]

May just go that route Rob

[staninlowerAL]

154 LoBoy tire pictures: The space at the point the white block is inserted is about 3.5 inches. The curve of the fender at the top clearance to the tire is 3 inches. At the bottom of the fender/footrest the clearance is 4 inches. If the curve of the fender was eliminated there would be 4 inches top to bottom. It might be possible to take a little more off the sheet metal and move the fender in even farther. These pictures are with the std one piece rims turned to the widest setting and 8.3 x 24 tires, don't know how this would work out with the 2 piece rims. Stan

[tractordad]

Stan,

Thanks for taking the time to post the pictures and take the measurements.

Gary

[SONNY]

Mine have the fat tires and spacers to keep the tires from rubbing the fenders, but there is no room between!--well maybe a finger width! thanks; sonny