Sticking Valves Again
Posted: Mon May 12, 2014 9:18 am
Gentleman,
Have not been on in a while, hope everyone is doing ok. After skipping the garden last year because of a new born and a 2 year old I am back in the game this year. I set up the middle toolbar with a shovel dead center to run my rows. It was running well and about halfway through the first pass I dropped a cylinder. I checked spark and it was good, with no change on number 2 when wire removed. I popped the cover and had a stuck valve again. I freed it up and ran it around a little more and it did it again but periodically. I just changed the oil. My question is this, should I be running a Zinc additive or any other you guys can recommend? Planting time is here and I do not want to be down for a rebuild. Winter project. Any advice would be appreciated. Thanks
I will take pics when I am back in the garden
Have not been on in a while, hope everyone is doing ok. After skipping the garden last year because of a new born and a 2 year old I am back in the game this year. I set up the middle toolbar with a shovel dead center to run my rows. It was running well and about halfway through the first pass I dropped a cylinder. I checked spark and it was good, with no change on number 2 when wire removed. I popped the cover and had a stuck valve again. I freed it up and ran it around a little more and it did it again but periodically. I just changed the oil. My question is this, should I be running a Zinc additive or any other you guys can recommend? Planting time is here and I do not want to be down for a rebuild. Winter project. Any advice would be appreciated. Thanks
I will take pics when I am back in the garden