Cub 22 mower pitman arm

[leerenovations]

Just got a new used Cub 22 mower and need to make a pitman arm. I hate to ask this because I know I am probaly overlooking it. Someone had a diagram on how tomake a pitman on here. I did a search and all I found was a hyperlink to the manual server and when I click it it says "server error". Does anyone have this diagram or plan readily available?

[Mr E]

Rudi's server is down. Try this link from Dennis

http://farmallcub.com/rudi_cub/www.cleancomputes.com/Cub/

[Barnyard]

Many of the files on Rudi's server are currently unavailable. While Dennis has been able to link to a lot of those files temporarily, the sketches file, which includes the pitman arm, is not available through the temporary link.

[tmays]

If you are close to a case/ih dealer, they can get it for bout $25.

[(CUB HUT)]

I haven't tried lately but T S C use too have them

[tst]

Hit this link, $18
http://www.madisontractor.com/451392r1- ... 0-500.html
Tim

[dmacarthur]

We used to make them sevaral at a time, rocky fields around here, some good clear ash and a good template.....

[leerenovations]

Hit this link, $18
http://www.madisontractor.com/451392r1- ... 0-500.html
Tim

Thanks for the link. And they are on sale for $17. I was just too tight fisted to want to spend money on something I could make. But the cheaper it gets, the more inclined I am to use my debit card.

As usual, you guys rock!

[Eugene]

Check your farm and ranch store. They usually have blanks for a few dollars. Just need to measure, drill the holes and cut to length.

[leerenovations]

Well, then can anyone tell me the total length and the distance to the first hole on either end? I know TSC sells blanks, but I saw on an earlier post that the TSC ones were a little smaller than the standard IH one. And I think someone said that that would cause problems like messing up the timing. But I forgot where I read that.