Page 1 of 1
Assembly Question
Posted: Thu Sep 26, 2013 6:01 am
by PVF1799
If I paint the steering column before assembly should I expect that installing the lower seal keeper will damage the paint? Is it possible to oil he seal and slide the assembly over the paint, without causing damage?
Ken
Re: Assembly Question
Posted: Thu Sep 26, 2013 6:15 am
by Cecil
It should not be a problem. I do it all the time.
Re: Assembly Question
Posted: Thu Sep 26, 2013 6:38 am
by PVF1799
Thanks Cecil - I've got a few more assembly questions that can wait till Saturday when we meet at PORKTOBERFEST at the farm.
Ken
Re: Assembly Question
Posted: Thu Sep 26, 2013 11:17 am
by Cecil
Ken we're looking forward to it. Been remodeling the downstairs bathroom this week. Tile on the floor, new toilet, and converting an antique dry sink into a vanity with a vessel sink. On top of that making molding for the kitchen and the bath. I need a break.
Re: Assembly Question
Posted: Thu Sep 26, 2013 3:55 pm
by Don McCombs
WHAT!!! You're changing the toy room???
Re: Assembly Question
Posted: Thu Sep 26, 2013 6:25 pm
by Cecil
Nope still the toy room. Just a good face lift.
Re: Assembly Question
Posted: Thu Sep 26, 2013 6:31 pm
by Don McCombs
Re: Assembly Question
Posted: Thu Sep 26, 2013 6:35 pm
by ricky racer
PVF1799 wrote::help: If I paint the steering column before assembly should I expect that installing the lower seal keeper will damage the paint? Is it possible to oil he seal and slide the assembly over the paint, without causing damage?
Ken
Make sure the vent hole in the filler cap is open or the oil will leak out the seal, new or not.
That baby is sure looking goooooood!!!!!!!!!!!!!!!!
Re: Assembly Question
Posted: Thu Sep 26, 2013 8:00 pm
by PVF1799
ricky racer wrote:Make sure the vent hole in the filler cap is open or the oil will leak out the seal, new or not.
That baby is sure looking goooooood!!!!!!!!!!!!!!!!
Ricky - about 5 months ago - I found that hole - Never knew it existed.....She's all clean and not filled with paint. Thanks for your comments.
Ken