Tue Apr 30, 2013 7:41 am
Is there suppose to be an o-ring on the safety relief? Also, there are 3 blue o-rings in the kit I haven't found a place for...yet. Am I suppose to use any type sealant under the head gasket? Thanks for the help.
Tue Apr 30, 2013 8:42 am
The three blue orings are not used. I do not use sealant on the gasket. You do not want sealant squeezing out and getting into the system.
Tue Apr 30, 2013 9:28 am
Blue orings are for the hydraulic lines connection at the hydraulic pump.
Tue Apr 30, 2013 10:52 am
Papa's Cub wrote:Is there suppose to be an o-ring on the safety relief?
Go to the "Manuals" section on the link (above right) and open the Blue Ribbon Touch Control manual. It'll have an exploded diagram of a T/C unit with index. Each seal (o-ring) is shown and labeled.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.