Farmall Cub

http://www.steinertractor.com/IHS496-battery-cable-hold-down-clip?&TF=C30B10B5ABB6

Where does this go?
Would it have been used on a 1948?

Ken

Yes, right hand side of dash, hangs beside clutch pedal and protects the battery cable from wear

Here are pictures of an original on TM. These look like the early style, which would be correct for your '48.

http://www.tm-tractor.com/gel/cableclip_001.htm

Here is a pic showing the location.

Thanks Barnyard - the darn thing has been gone so long from our Cub I could not recall. I actually didn't notice in the parts manual either. I'm quite certain someone here will tell me what page it's on.

Last question - it appears that the bracket supplied by Steiner gets twisted a bit when installed so it screws in to the dash. Is that screwed in the the vertical screw or the small one in the picture just above the bracket?

As always thanks, Ken

PVF1799 wrote:http://www.steinertractor.com/IHS496-battery-cable-hold-down-clip?&TF=C30B10B5ABB6

Where does this go?
Would it have been used on a 1948?

Ken

This bracket goes at the top of the dash and hood connection to hold the wiring and battery cable going forward The other bracket goes at the lower right dash to hold and protect the battery cable and wiring going to battery and rear light.

Here are the clips as found on my latest Cub.

Top


Bottom

Ken,
Here is a link for the clip that you need.

http://www.defarmallcubs.com/ELECTRICAL.html Item EL-323

It takes the early clip for 6 volt cable.

Oh my - I love this forum! So much help in so little time. The pix are awesome - So I'll need to order two of them....Thanks All.

Ken - you only need one, unlss you have two Cubs you're working on. In my parts catalog, in the electrical section for early Cubs (which is on page 25) it is Ref No 12, Part No 363 504 R1. This clip is a long one to shield the battery and rear light cable from chafing by the clutch pedal or the operators big "ol field boot" soles. There are other clips under the platform and along the underside of the hood, but they are all smaller - perhaps 3/4 inch in width. The one we're talking about is at least 2 inches long. My cub is down the street, otherwise I would try to attach a picture. Al D

Barnyard wrote:Here are the clips as found on my latest Cub.

Top


Bottom

Thanks CubStar - I was looking the pix set by Barnyard - it shows one by the clutch - the other is up, just under the gas tank.

Ken

I think the upper one on Barnyard's tractor wandered in from another tractor. By the way, there was a later version of the clip, evidently that came along the same time they added a ground wire for the lights. The rear light wire that went through this clip got upgraded to a 2-wire cable and the clip was enlarged. Most of the pictures in this thread seem to be the early style, which is correct for a '48.

the one under the tank i have found on most cubs early sixties and up
tim

Hi,
I remember in the mid 1970's I bought one of the clips that goes by the clutch pedal new at a IH dealer, I remember the price, it was $1 then. It has a soft coating to hold the cables. I still have it on my tractor. I wish things still cost what they did then. Good luck with your Cub, Glen.