9/16-18 thread, stripped carb inlet
Posted: Sat Mar 09, 2013 5:10 pm
Clearly the carb inlet's been stripped out at least twice now. It's a leaker.
What little thread that's left is definitely 9/16-18.
The carb came with an oddball compression fitting, one side 5/16" compression, the other side 9/16-18 threaded.
Is the hole too big for a helicoil?
Should I just JB weld the compression fitting into the carb ala Lurker Carl?
What little thread that's left is definitely 9/16-18.
The carb came with an oddball compression fitting, one side 5/16" compression, the other side 9/16-18 threaded.
Is the hole too big for a helicoil?
Should I just JB weld the compression fitting into the carb ala Lurker Carl?