Thu Mar 07, 2013 12:35 pm
I know I've seen a Diagram of How to R&R a Hydraulic Block Assy on this forum, but, I can't seem to find it now. Would someone please direct me to it again. I'm ready to attempt the task and a copy of step-by-step directions would really boost my confidence. Thanks.
Thu Mar 07, 2013 12:46 pm
Fri Mar 08, 2013 11:37 am
Thanks Bob. This is the site I was looking for. I installed a kit in the pump a few months back and that stopped the oil from leaking into the engine. Now I trust I can stop the block from leaking. Thanks Again!
Sun Mar 10, 2013 12:19 pm
I would make sure I knew where the touch control was actually leaking from before committing to a complete rebuild. Lots of times it's just the o-rings on the control rod, a relatively easy repair compared to disassembling the entire thing to "repair" functional parts.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.