Page 1 of 1
choke rod
Posted: Wed Feb 20, 2013 10:04 am
by Jack
I was out plowing snow the other day, and notice that my choke rod would keep coming out about half way, when I was running the tractor. I would push it all the way back in and it would keep coming back out. and suggestions on how to keep it in? should there be a spring of some sort? attached to the linkage
thank you
Jack
Re: choke rod
Posted: Wed Feb 20, 2013 10:09 am
by Barnyard
Jack, was it affecting the running of the Cub? If not, check to make sure it didn't come loose from the carb.
Re: choke rod
Posted: Wed Feb 20, 2013 11:38 am
by Boss Hog
Check and see, but I expect the lever is loose on the shaft
Re: choke rod
Posted: Wed Feb 20, 2013 2:24 pm
by Paul Van Benschoten
I have this problem also, and it does affect how the cub runs.
It usually happens when going uphill or when using 3rd gear and it ALWAYS happens going uphill in 3rd
Re: choke rod
Posted: Mon Feb 25, 2013 6:44 am
by Jack
yes it does effect how it runs, that is how I noticed it was coming out. I will check it at the carb this weekend when I get back up there.
thanks guys
Re: choke rod
Posted: Mon Feb 25, 2013 7:41 am
by challenger
The IH carb is supposed to have a flat spring with a raised ridge on it that fits in a slot on the carburetor. It is located under the choke lever or arm and it is supposed to lightly push up against the choke arm which has two mating indentations to receive the spring. The purpose is to provide a more definate positioning of the choke in the open and closed postions. I have one carb with the spring and one where the spring has been lost. I think the flat spring is just pushed into the slot in the carb.
Re: choke rod
Posted: Mon Feb 25, 2013 9:45 am
by Jack
thanks for all the help