Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Wed Jan 30, 2013 4:20 pm
hey guys took manifold off the side of touch control houseing going to replace the gasket thought there might be some o rings did not see any guess it is gasket only i no there are 2 o rings on pump mainfold want to make sure before i put gasket Also going to pull touch control houseing so i can clean everything up do i need to order a bottom houseing gasket or can i clean it all up and use some form a gasket talking about where touch control bolts down on tractor Thanks fellows
Wed Jan 30, 2013 5:38 pm
Where manifold bolts to tractor is gasket only. There is no gasket under the unit, just metal to metal. You will not need a gasket unless you take the bottom plate off the touch control. If you do that, ge6t a gasket, rather than form a gasket. I tiny spec of the form a gasket getting inside the system can easily cause a complete rebuild.
Wed Jan 30, 2013 5:51 pm
Hey there, Johns got you covered. You can try this site though, it's listed under "manuals" at the top of this page. http://www.cleancomputes.com/Cub/Blue%2 ... index.html
, for some reason it's not working right now. Ordinarily it works well and it's a great source for anything Cub related. Good luck!
Thu Jan 31, 2013 1:34 pm
It is up and working. Not sure what the problem was for you.. could have been as simple as a power bump.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.