Wed Jan 30, 2013 4:20 pm
hey guys took manifold off the side of touch control houseing going to replace the gasket thought there might be some o rings did not see any guess it is gasket only i no there are 2 o rings on pump mainfold want to make sure before i put gasket Also going to pull touch control houseing so i can clean everything up do i need to order a bottom houseing gasket or can i clean it all up and use some form a gasket talking about where touch control bolts down on tractor Thanks fellows
Wed Jan 30, 2013 5:38 pm
Where manifold bolts to tractor is gasket only. There is no gasket under the unit, just metal to metal. You will not need a gasket unless you take the bottom plate off the touch control. If you do that, ge6t a gasket, rather than form a gasket. I tiny spec of the form a gasket getting inside the system can easily cause a complete rebuild.
Wed Jan 30, 2013 5:51 pm
Hey there, Johns got you covered. You can try this site though, it's listed under "manuals" at the top of this page. http://www.cleancomputes.com/Cub/Blue%2 ... index.html
, for some reason it's not working right now. Ordinarily it works well and it's a great source for anything Cub related. Good luck!
Thu Jan 31, 2013 1:34 pm
It is up and working. Not sure what the problem was for you.. could have been as simple as a power bump.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.