grader blade question

[tst]

Hi all, I have a model 54 snowplow/grader blade that is missing the round rod that goes from the rockshaft down to pivot arm, would some one have one that they could measure the lenght so I can make one?, you can see the round rod in this picture from TM tractor
thanks Tim

Attachments

[Winfield Dave]

Tim...does this help?
http://farmallcub.com/phpBB2/viewtopic.php?f=1&t=17896

[EarlyCub49]

Hi all, I have a model 54 snowplow/grader blade that is missing the round rod that goes from the rockshaft down to pivot arm, would some one have one that they could measure the lenght so I can make one?, you can see the round rod in this picture from TM tractor
thanks Tim

Tim, I just measured mine, it is 23 inches center to center.

Bruce T.

[tmays]

Tim...does this help?
http://farmallcub.com/phpBB2/viewtopic.php?f=1&t=17896

That's excellent! First time I've seen it.

[tst]

Thanks guys for the help
Tim

[lazyuniondriver]

If function before fashion isn't a problem, and you plan on doing more grading work than snow removal, you may want to add a 1" piece of angle iron down the length of the rod to reinforce it from bending.

Attachments

1353807141-picsay.jpg (48.98 KiB) Viewed 201 times