Farmall Cub

i had to take the pulley off the center spindle and forgot that the center sheave is split, are these still available?

Hi Rob, yes they are available through the dealers, also I see Hamiliton Bob now has repops for these
Tim

thanks tim, now my next question,the reason why i took it off was because of the bearings have gone bad, would anyone have the numbers for the bearings and seals?

BOB IN N.H.

WHEN YOU START TO PUT IT BASK TOGETHER BE SURE THE TOP SEAL HOLDS
GREASE IN BOTTOM SEAL HOLDS DIRT OUT AND LETS GREASE OUT--------FILL IT
FULL OF GREASE WHEN PUTTING IT BACK-------WITH ONLY ONE GREASE FITTING
TO WORK GREASE THROUGH TO BOTTOM BEARING-----YOU CAN STILL USE THE
SPLIT HUB AS LONG AS YOU HAVE A BOLT IN EACH PEACE----


GOOD LUCK
LOMBARD----SC---
MY $0.08---

You may be able to cross the bearings with the IH part numbers. I would guess that they are Timken tapered roller bearings with CR or National seals. The numbers may be on the parts.

Or just call C&G.

http://partstore.caseih.com/us/parts-se ... :mr02-1092

Looks like my favorite parts guy already answered the question.... (found it searching for the IH seal part number)

viewtopic.php?f=1&t=16239

thanks larry, thats what i needed