Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Sun Nov 18, 2012 9:15 pm
If I recall correctly, there was a thread a while back (well...quite a while back) that showed a how-to for retrofitting the pancake lights with the teardrop reflector. I looked in the how-to section under electrical, and cannot seem to find it.
Thanks for any help you all can give...
Sun Nov 18, 2012 10:04 pm
I see those are in the sheet metal forum. I will move them to the ignition/electrical forum to cause less confusion.
Sun Nov 18, 2012 10:12 pm
Here is the 2 post bulb in my pancake light.
Sun Nov 18, 2012 11:16 pm
Dan, do you have any pics of how you wired and fit yours into those housings?
Mon Nov 19, 2012 6:42 pm
No pics showing the details, and it has been a few years since this was done.
Seems there was a couple of glass tabs on the back side of the bulb near the outer edge that I had to grind down some with a high speed grinder. I was successful in doing this without breaking either of the bulbs. The screw lugs on the back were pressed down as close to the back of the bulb as possible. Two wraps of electrical tape around the outer edge of the bulb to hold it tight in the housing. The existing hole in the back of the pancake housing was plugged with a plumbers rubber plug cap like you see on some new fittings etc. A smaller hole allowing the wires to exit the pancake housing. I don't remember needing any other insulating material between the bulb screws and the back of the housing. I could be wrong though.
This was done in 2005 and they continue to work great yet today.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.